This weekend I finish the press.
After a few weeks and many coats of polyurethane, we get this.
Very shiny 🙂 In period, they would have waterproofed with linseed oil and I could have done that. My friend has poly so we used that.
Next we drive the stay for the press screw through the upper support. We did use a dremel to widen the hole a bit and I didn’t do as good of a job as I could have. There is a little bit of splintering but not too bad.
On the top side, we add the set screws.
Then we add some feet to the base plate.
Here is all the parts before we add the rods to make the frame. The foot of the press screw is just a set screw on the bottom.
We cut some PVC pipe that will provide some vertical support and protect the long screws.
The photo of the long screws inside of the PVC didn’t turn out. Here is the finished press.